Perle Systems 5500161-40 - Manual (Page 64)

DHCP/BOOTP
64 IOLAN SDS/SCS/STS/MDC User’s Guide, Version 4.0
DHCP/BOOTP Parameters
The following parameters can be set in the DHCP/BOOTP bootp file:
z SW_FILE—The full path, pre-fixed by hostname/IP address (IPv4 or IPv6), and file name of the
firmware update.
z CONFIG_FILE—The full path, pre-fixed by hostname/IP address (IPv4 or IPv6), and file name
of the configuration file.
z GUI_ACCESS—Access to the IOLAN from the HTTP or HTTPS WebManager. Values are on
or off .
z AUTH_TYPE—The authentication method(s) employed by the IOLAN for all users. You can
specify the primary and secondary authentication servers, separated by a comma. This uses the
following numeric values for the authentication methods.
– 0—None (only valid for secondary authentication)
– 1—Local
– 2—RADIUS
– 3—Kerberos
– 4—LDAP
– 5—TACACS+
– 6—SECURID
– 7—NIS
z SECURITY—Restricts IOLAN access to devices listed in the IOLAN’s host table. Values are
yes or no .
z TFTP_RETRY—The number of TFTP retries before aborting. This is a numeric value, for
example, 5.
z TFTP_TMOUT—The time, in seconds, before retrying a TFTP download/upload. This is a
numeric value, for example, 3.
z CUSTOM_LANG—The full path, pre-fixed by a hostname/IP address (IPv4 or IPv6), and file
name of a translated language file. For example,
192.101.34.211 /accounting/Iolan_ds_german.txt.
z EXTRA_TERM1—(EXTRA_TERM2, EXTRA_TERM3) The full path, pre-fixed by a
hostname/IP address (IPv4 or IPv6), and file name of a termcap file for a specific terminal type.