Perle Systems 5500161-40 - Manual (Page 379)

Setting Jumpers 379
Introduction
1-Port IOLAN DB9
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
Power
DIP
Switch
Reset
RJ45
DB9 Ser
ial
Screw
Screw
J1
J9
3. To turn line termination on , locate and jumper both J1 and J9.
4. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
2-Port IOLAN SDS1M (Modem)
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
Power
DIP
Switch
Reset
RJ45
RJ45 Serial
Pin1
Screw
Screw
J8
J4
J7 Modem
3. To change the power pin out, locate J4. For the fixed 5V DC output, jumper pins 1 and 2. For the
output to equal the external adapter input, jumper pins 2 and 3.
4. To turn line termination on , locate and jumper both J7 and J8.
5. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.