Psion Teklogix 9160 G2 - Manual (Page 160)

Chapter 12: The Ethernet (Wired) Interface
Configuring Guest Interface Ethernet (Wired) Settings
138 Psion Teklogix 9160 G2 Wireless Gateway User Manual
12.1.5 Configuring Guest Interface Ethernet (Wired) Settings
To configure Ethernet (Wired) Settings for the “Guest” interface, fill in the fields as
described below.
12.1.6 Updating Settings
To update Ethernet settings:
1. Navigate to the Ethernet Settings page.
2. Configure the ethernet settings as required.
3. Click the Update button to apply the changes.
Default Gateway Enter the Default Gateway in the text boxes.
DNS Nameservers The Domain Name Service (DNS) is a system that resolves the descriptive name (domainname)
of a network resource (for example, www.psionteklogix.com) to its numeric IP address (for
example,
66.93.138.219 ). A DNS server is called a Nameserver.
There are usually two Nameservers; a Primary Nameserver and a Secondary Nameserver.
You can choose Dynamic or Manual mode.
• If you choose Dynamic, the IP addresses for the DNS servers will be assigned
automatically via DHCP. (This option is only available if you specified DHCP for the
Connection Type.)
• If you choose Manual, you should assign static IP addresses manually.
Field Description
MAC Address Shows the MAC address for the Guest interface for the Ethernet port on this access point. This is a
read-only field that you cannot change.
VLAN ID If you choose to configure Internal and Guest networks by “VLANs”, this field will be enabled.
Provide a number between 1 and 4094 for the Guest VLAN.
Subnet Shows the subnetwork address for the Guest interface. For example, 192.168.1.0 .
Table 12.5 Configuring Guest Interface Ethernet Settings
Field Description
Table 12.4 Ethernet Settings For Internal LAN