Psion Teklogix 9160 G2 - Manual (Page 145)

Psion Teklogix 9160 G2 Wireless Gateway User Manual 123
Chapter 11: Maintenance And Monitoring
Log Relay Host For Kernel Messages
11.2.1.3 Enabling Or Disabling The Log Relay Host On The Status,
Events Page
To enable and configure Log Relaying on the Status > Events page, set the Log
Relay options as described below and then click Update.
Update Settings
To apply your changes, click Update.
If you enabled the Log Relay Host, clicking Update will activate remote logging.
The access point will send its kernel messages real-time for display to the remote
log server monitor, a specified kernel log file, or other storage, depending on how
you configured the Log Relay Host.
If you disabled the Log Relay Host, clicking Update will disable remote logging.
Field Description
Relay Log Choose to either enable or disable use of the Log Relay Host:
If you select the Relay Log checkbox, the Log Relay Host is enabled and the Relay Host and Relay
Port fields are editable.
Relay Host Specify the IP Address or DNS name of the Relay Host.
Note: If you are using Devicescape Wireless Operations Center, the Repository Server
should receive the syslog messages from all access points. In this case, use the IP
address of the Operations Center Repository Server as the Relay Host.
Relay Port Specify the Port number for the syslog process on the Relay Host.
The default port is 514.
Table 11.1 Log Relay Host Settings