2 configuring security settings – Psion Teklogix 9160 G2 User Manual
Page 121
Psion Teklogix 9160 G2 Wireless Gateway User Manual
99
Chapter 10: Configuring Security
Configuring Security Settings
10.2 Configuring Security Settings
To set the security mode, navigate to the Security tab, and update the fields as
described below.
The following configuration information explains how to configure security modes
on the access point. Keep in mind that each wireless client that wants to exchange
data with the access point must be configured with the same security mode and
encryption key settings consistent with access point security.
On a two-radio AP, these Security Settings apply to both radios.
Note:
Security modes other than Plain-text apply only to configuration of the
“Internal” network. On the “Guest” network, you can use only Plain-text
mode. (For more information about guest networks, see Chapter 14: “Set-
ting up Guest Access”.)
10.2.1 Broadcast SSID, Station Isolation, And Security Mode
To configure security on the access point, select a security mode and fill in the
related fields as described in Table 10.5.