Pitney Bowes J693 - Manual (Page 83)

J693 73
Warning Messages:
Displayed Message Description Action
"
The printer has
detected burned-
out printhead
elements. Replace the printhead when
print quality becomes
unacceptable or if the
printed bar codes are non-
compliant.
"
The printer missed
detecting a label
gap. Readjust the media sensor
and recalibrate.
#
Power has been
removed and
shutdown is in
progress. The printer power switch
was turned ‘Off’, the line
fuse has blown, or AC line
voltage has been lost.
"
The host has
pending
configuration
changes that will
not take effect until
a ‘host reset
command’ is
issued. To save changes, send a
host reset command (in
DPL) or to discard changes
perform a front panel reset;
see Section 4.0.6.
"
The printer has
detected a low
operating voltage. A possible low or
fluctuating line voltage
level. Try moving the
printer to another outlet. If
this condition persists call
for service.
##
Ribbon will soon
need replacement. Replace ribbon when
needed.
" "
The printer was
unable to save
settings in
permanent
memory. If the condition persists,
possible faulty Main PCB.
Call for service.
(Continued next page)