Pitney Bowes J693 - Manual (Page 17)

J693 7
3.1 Loading Media
The following procedures explain the preliminary label loading steps.
n Raise the Access Cover.
o
Rotate the Printhead Latch
forward to raise the printhead.
p
Slide the Label Guide out away from the frame and then lower it to the
down position.
Note: In this left-justified printer, always place the labels against the
backstop when loading.
q Pull outward on the Roller Bracket and allow it to swing down.
r Load labels and advance approximately 20 inches of labels from the front
of the printer. Remove the labels from the entire length, leaving only the
backing material.