Pitney Bowes J693 - Manual (Page 70)

60 J693
5.6.1 Updating from the Ready Mode
Update Procedure for Application Version 2.091 or greater
Step Displayed Message Operator Action Comment(s)
1.
"
Using the DOS
copy command
(where ‘filename’
is the program to
be loaded and
‘lpt1’ is the
selected interface
port), enter the
following:
copy filename lpt1:
As an example, this would be
entered as:
copy
4212tb10_0304.zs lpt1:
(where ‘lpt1’ is the host
computer’s port; however,
this selection can differ to
include a serial or other port,
as the printer is equipped).
The Ready Indicator will
flash while the data is
received.
2. "
"
No action required. The new application program
is being stored and verified.
3. USRS
TOQU QXPSWPSQQQ
No action required. The printer has reset
automatically and is now
displaying the new firmware
version.
4.
"
No action required. The new application is now
running.
; ;
Note: If ‘Uncalibrated’ or
‘Position Fault’ is displayed,
the printer will have to be
calibrated (see Section
5.2).