Pitney Bowes J693 - Manual (Page 55)

J693 45
Step Operator Action Displayed Message Comment
10 Place the label (and
backing) under the Sensor
Eye Mark.
Press any key to continue.
" "
" ]<<<_
Calculates the
parameter
settings for the
‘Paper’ value.
‘yyy’ is a
numerical value
representing the
current sensor
reading.
11 Depending upon the
‘Sensor Type’ selection,
observe the display for the
calibration message.
"
"
#"
-OR-
"
#"
-OR-
"
#"
See
‘Calibration
Problems’
(listed below)
for other
possible
messages.
12 Exit upon successful
calibration: press the
key to back out
of the menu tree, when
prompted to save the
settings press the
key to return to the Main
Menu.
" "`
^
After saving the
settings, press
and hold the
FEED key,
approximately
4 seconds, to
calibrate the
label position.