Pitney Bowes J693 User Manual
Page 21
J693
11
p
Mount the ribbon so that it is dispensed in the appropriate direction for the
ribbon type.
q
Slide the ribbon on completely to rest against the flange.
r
Route the ribbon under the Ribbon Roller then out the front of the printer.
s
Continue routing the ribbon up to and around the Ribbon Take-Up Hub, as
shown. Wind the ribbon around several times in a clockwise direction to
secure it in place.
t
Lower the printhead and rotate the Printhead Latch back to the locked
position. Close the Access Cover.
u
With the printer ‘On’ press and hold the FEED button for three seconds to
position the labels for printing; see Section 5.2 for details.
Ribbon routing path
Ribbon Removal:
Pull the empty core from the Ribbon Supply Hub and discard it. Next, grasp
the used ribbon on the Ribbon Take-Up Hub, while gently pulling out on the
hub, compress the hub to pull off the used ribbon.