Status, Meters, Active alarms – Powerware 5140 User Manual
Page 45
Front Panel Menus
37
Powerware
®
5140 User’s Guide
:
www.powerware.com
Status
The Status option displays the current UPS operation mode or
condition. Use
?
and
+
to toggle between the current load segment
configuration and the number of currently active alarms. Press
to
automatically enter the Load Control menu or the Active Alarms menu.
Load Segments
Active Alarms
UPS Status
Meters
The Meters option displays information about the UPS voltages. If
necessary, use
*
and
to scroll left or right to read the meter values.
Use
?
and
+
to view the following metered values:
: Input Volts
: Output Volts
: Input Frequency (Hz)
: Output Frequency (Hz)
: Output Power - Shown as a bar chart with each block representing
approximately 10% of the total load. The vertical bar represents the
full load point; anything past the vertical bar represents an overload
condition.
: Battery Volts
Active Alarms
The Active Alarms option displays a description of each active alarm.
The UPS generates the following alarm conditions:
: Input AC Over Voltage
: Input AC Under Voltage
: Input Over or Under Frequency
: Output Overload
: Inverter Fault