Kodak EasyShare 5500 - Manual (Page 83)

Fax
Error correction
When error correction mode is enabled, it eliminates data that is lost due to poor phone lines by detecting
errors that occur during transmission and automatically requesting re-transmission of the erroneous
portion. On poor phone lines, error correction mode increases sending time but sends the data much more
reliably. The default setting is Off. Turn error correction On only if you can accept poorer quality faxes. If
you turn error correction On, this only affects black and white faxes that you send; it does not affect faxes
that you receive. If you are having problems sending faxes, you can also adjust the fax speed to see if this
solves the problem. For more information on fax speed, see Fax speed.
1 Press Menu to display the main menu.
2 Press
b
until Fax Settings is displayed.
3 Press OK to display the Adjust Fax Settings menu.
4 Press
b
until Error Correction is selected.
5 Press
_
or
`
enable or disable Error Correction.
Fax speed
You can set the fax speed used to communicate between your Kodak EasyShare All-in-One and other fax
machines when sending and receiving faxes. The default fax speed is Fast (33.6K).
If you experience problems sending and receiving faxes, you might want to try setting the fax speed to
14.4K Baud (v.37) or 9.6K Baud (v.29).
1 Press Menu to display the main menu.
2 Press
b
until Fax Settings is displayed.
3 Press OK to display the Adjust Fax Settings menu.
4 Press
b
until Fax Speed is selected.
5 Press
_
or
`
change the fax speed.
Sending a fax
You can send a fax by dialling the number using the control panel keypad with redial, speed dial or
phonebook.
User’s Guide 79