Install the duplexer – Kodak EasyShare 5500 User Manual
Page 18
Chapter 2
4
Press down on the ink cartridge until you hear it snap into position.
5
Tear open the colour ink cartridge bag at the notch and remove the ink cartridge.
6
Remove and discard the orange cap.
7
Insert the colour ink cartridge into the printhead.
8
Press down firmly on the cartridge until you hear it snap into position.
9
Close the printer access door.
NOTE: For the best quality prints, store ink cartridges in a location where the temperature does not
exceed 30°C (85°F).
Install the duplexer
The Kodak AiO printer supports an optional duplexer (Kodak EasyShare 5000 Series two-sided printing
accessory) that enables printing on both sides of the paper. When installed, the duplexer is automatically
detected by the printer and computer system software.
The duplexer is limited to plain paper (no photo paper). The paper dimensions that can be used are from
17.5 to 21.6 cm (6.9 to 8.5 inches) wide and from 24.9 to 29.7 cm (9.8 to 11.7 inches) long.
14
Kodak EasyShare 5500 AiO