Kodak EasyShare 5500 - Manual (Page 101)

Support
Bluetooth device not recognised
Probable cause 1
The internal Bluetooth radio in the device may be turned off.
Corrective action
Make sure the device is on and within range of the Bluetooth radio signal (10 metres or 30 feet).
NOTE: The Bluetooth technology-enabled device must use a BIP, OPP or FTP profile.
Probable cause 2
Sending device requires a PIN.
Corrective action
Enter a PIN of 1111 into the sending device.
Device not recognised
Any of the following can prevent your Kodak AiO printer from reading a connected digital camera or
memory card.
„ The camera is turned OFF.
„ The USB connector from the camera is not fully inserted in the port.
„ The memory card is not completely inserted.
„ The memory card is in backwards.
„ The memory card file system is corrupt.
Correct any connection problems and try again.
If the memory card file system is corrupt, reformat it in your camera.
Ink cartridge
Colour/Black cartridge not recognised
The ink cartridge installed was not recognised. Generic or non-Kodak ink cartridges may not function in
the KODAK EASYSHARE All-in-One Printer. Kodak recommends using Kodak ink cartridges.
To correct the problem, install a genuine Kodak ink cartridge.
Ink cartridge out of ink
One of the ink cartridges has reached the end of its life and needs to be replaced.
To correct the problem, replace the empty ink cartridge.
Multiple paper feed
Multiple sheets of paper are pulled through the printer.
User’s Guide 97