Kodak EasyShare 5500 - Manual (Page 40)

Chapter 4
Two-sided printing
You can print on both sides of the paper.
Watermark
You can select or create a background watermark.
Print photos from a camera
1 Connect your camera to the AiO printer. The PictBridge logo is displayed on the LCD.
2 Load the photo tray with photo paper (See Load photo tray in Chapter 3).
3 Use your camera to select and print photos.
Print photos from the control panel
The Photo Print mode is initiated by pressing the Photo button, inserting a memory card or connecting a
USB device to the Kodak EasyShare All-in-One.
1 Insert a memory card into the appropriate slot or a mass storage device into the USB port, or connect a
digital camera to the USB port. The last photo is displayed.
WARNING
Never attempt to remove a memory card while it is being accessed. Doing so may damage
files on the card. You can safely remove a card only when the status light next to the slots is
not blinking.
2 Load the main tray (see Load main tray in Chapter 3) or photo tray (See Load photo tray in Chapter 3)
with photo paper.
NOTE: The photo tray only supports 150 x 100 mm (6 x 4") photo paper.
3 Press
a
to select the number of prints for this photo.
4 Press
`
to preview the next photo.
TIP: To select all the photos on a memory card or mass storage device, hold down the OK button for 2
seconds. Holding down the OK button again for 2 seconds will de-select all the photos.
5 Repeat steps 3 and 4 until you have finished selecting photos.
6 Press Start to print the selected photos or Photo to set print options.
7 Set print options.
See Set print layout
See Set number of prints
See Set Colour
See Set print quality
After a photo is printed, it is de-selected.
36 Kodak EasyShare 5500 AiO