Location, Environment, Regulatory compliance – Kodak EasyShare 5500 User Manual
Page 115: Fcc compliance and advisory
Appendix
Location:
CAUTION
To prevent your AiO printer from overheating, do not block or cover the slots and openings in
the equipment, place it near a heat register or install it in a cabinet without proper ventilation.
CAUTION
Do not use your AiO printer near water or spill liquid on it.
WARNING
Do not place your AiO printer on an unstable cart, stand, bracket or table. Injury to persons
and damage to the equipment may occur.
Environment
CAUTION
Excessive dust levels may damage internal parts.
CAUTION
Unplug the equipment from the wall outlet before cleaning.
CAUTION
Dropping your AiO printer may damage the housing and result in extensive damage that will
require repair by a qualified technician to restore normal operation.
WARNING
Do not expose this product to liquid, moisture or extreme temperatures. KODAK AC
adaptors are intended for indoor use only. The use of controls, adjustments or procedures
other than those specified herein may result in exposure to shock and/or electrical or
mechanical hazards.
For more information, go to
Regulatory compliance
FCC Compliance and Advisory
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed or used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
User’s Guide
111