Kodak EasyShare 5500 - Manual (Page 26)

Chapter 2
4 Press
b
until Scene Balance is selected.
5 Press
_
or
`
to enable or disable Scene Balance.
6 Press OK.
Add Date to Prints
You can set your AiO printer to print the date a picture was taken on the photo print. The default is to not
print the date.
1 Press Menu to display the main menu.
2 Press
b
to select Photo Print Settings.
3 Press OK.
4 Press
b
until Add Date to Prints is selected.
5 Press
_
or
`
to enable or disable date printing.
6 Press OK.
Button Sounds
You can configure your AiO printer to emit an audio feedback beep when you press a button on the control
panel. The default setting is to beep.
1 Press Menu to display the main menu.
2 Press
b
until Control Panel Settings is selected.
3 Press OK.
4 Press
_
or
`
to enable or disable button sounds.
5 Press OK.
Minutes to standby
When the Kodak EasyShare All-in-One is idle for the standby power setting timeout period, it enters the
Standby state. The On/Off indicator remains lit, but power consumption is reduced. When in the Standby
state, any activity such as a single button press or inserting a memory card brings the AiO printer out of
the Standby state and returns it to the Ready state.
NOTE: Faxes and print jobs from wireless devices (included PCs linked over the WLAN) can be received
while in standby.
You can set the standby timeout from 10 – 30 minutes. The default setting is 30 minutes.
1 Press Menu to display the main menu.
2 Press
b
until Control Panel Settings is selected.
3 Press OK. The Power Settings menu is displayed with Minutes to Standby selected.
4 Press
_
or
`
to change the standby timeout period.
5 Press OK.
22 Kodak EasyShare 5500 AiO