Kodak 8660 - Manual (Page 64)

Novell NetWare
6-6 Part No. 6B4389 June 1999
XConfig
1. Insert the diskette that came with the NIC into the disk drive.
Enter:
A:XCONFIG.
2. Select the NIC from the list of print servers. Press ENTER
when the message that the NIC is connected appears.
3. Enter the password access when the # prompt appears.
4. Press ENTER when the Enter Username> prompt appears.
5. When the Local> prompt appears, enter:
SET NETW NPRINTER pserver number ON service
SET NEW RESCAN
EXIT
Pserver is the name of the printer/NIC on your file server. Number
is the printer number which must match the printer number you
selected during the PCONSOLE configuration in the previous
steps. Service is the name of the service where the default
service is KOD_xxxxxx. The xxxxxx is the last 6 digits of the
Ethernet address. For example, to set up remote printer 3 on the
NIC, KOD_00C3E4 using the printer/NIC called KOD1PS, you
would enter:
SET NETW NPrinter KOD1PS 3 ON KOD 00C3E4 P1
SET NETW RESCAN
EXIT
NOTE: You cannot use the same service for both queue server
mode and remote printer mode.
To enable remote printer capabilities on services other than the
default NetWare services, define the new services that are
enabled for NetWare and the desired port. Refer to Appendix A
for more information.
6. Reload the PSERVER NLM from your NetWare file server
console to apply the changes.