Kodak 8660 - Manual (Page 41)

Using Configuration Utilities
Part No. 6B4389 June 1999 3-17
The serial port always operates at 9600 bps with no parity, XON/
XOFF flow control, and 8-bit characters when in console mode.
Make sure that your terminal is set to these parameters.
NOTE: Refer to Appendix B for a summary of commands and
syntaxes for use with XConfig, Telnet or serial port
sessions with the NIC.
Configuring the NIC from the Printer’s Display Panel
Some NIC parameters can be configured from the printer’s
display panel.
Keys on the printer control panel can be used to:
• enter the Setup menu (Setup/Select key).
• scroll up through menus (Print key).
• scroll down through menus (Cancel key).
• select items (Setup/Select key).
Setup menu items can either be viewed for status or configured to
accommodate your network printing environment. Use the scroll
keys to scroll to the next number.
1. When the printer is in the Ready state, select Setup.
2. Scroll through the menu items to select Status or Ports for
NIC parameters.
3. Exit the setup mode.
4. Reset the NIC to save any configuration changes.
The following items are available on the Status menu for the NIC:
Status> NIC> Serial #
FW Version
Link