Kodak 8660 - Manual (Page 38)

Using Configuration Utilities
3-14 Part No. 6B4389 June 1999
4. Type Help for further assistance.
NOTE: Refer to the configuration command section in Appendix B
for a summary of commands and syntaxes for use with
XConfig, Telnet or serial port sessions with the NIC.
Telnet Configuration Utility (Any Platform)
The Telnet utility is not provided with the NIC as utility
software.Telnet is typically provided with any system that
supports communications with TCP/IP.
XConfig and Telnet are essentially equivalent command line
interfaces. However, Telnet requires that an IP address first be
established on the NIC.
An IP address can be established in a variety of ways. One
method is to enter an IP address on the printer’s front display
panel by entering the setup menu and following the prompts.
Refer to the Operator’s Guide on the CD that came with the
printer for more information on using the Setup menu.
1. A Telnet session is typically established by entering the
following command line: