Kodak 8660 - Manual (Page 36)

Using Configuration Utilities
3-12 Part No. 6B4389 June 1999
Using XConfig Utility
The XConfig utility is provided with the NIC for use with Windows
operating systems. Use the setup utility to install XConfig along
with XAdmin. XConfig is a command line interface that can be
used to issue commands and get a status from the NIC.
XConfig and Telnet are equivalent command line interfaces.
XConfig does not require a prior address configuration if your
system is configured to support IPX. (The NIC can be selected
from its default “KOD_xxxxxx_P1” address.) However, Telnet
requires that an IP address first be established on the NIC.
1. To start XConfig, either use the Win 95/NT Start > Programs
> XAdmin > XConfig mechanism or click on the XConfig
executable which is installed in the XAdmin folder.
If you have one printer with a NIC installed, you will are
immediately connected. If you have more than one NIC, a
screen appears that gives you a list of available NICs.
2. Select the appropriate NIC represented as KOD_xxxxxx_P1.