Kodak 8660 - Manual (Page 24)

Installing the Hardware
2-8 Part No. 6B4389June 1999Au-
4. If this is the first time you are setting up or verifying NIC
operation, push in on the NIC test button for at least five
seconds to set all of the NIC configuration parameters to
factory defaults.
5. Push in on the test button again for approximately a second
(less than 5 seconds) to print a test page.
Retain the test print. It contains information you will need to
configure the NIC.
If the test page does not print:
• make sure that the NIC is installed securely in the printer.
• check the LEDs on the bottom of the NIC. When you turn on
the power to the printer, the NIC runs a set of power-up
diagnostics. If the NIC operates correctly, the red test LED
blinks momentarily and then goes out. The test LED blinking
continuously indicates a problem with either the installation of
the NIC or the Ethernet cable.
Refer to the chapter “TroubleShooting” for more information on
diagnosing the problem.
Configuring the NIC
If the NIC test page printed, configure the NIC for network printing
only if you wish to change the default settings. Refer to “Using
Configuration Utilities” for information on the various utilities that
you can use to configure the NIC.