Siemens MICROMASTER 411 - Manual (Page 77)

Issue 03/01 5 System Parameters
MICROMASTER 411 & COMBIMASTER 411 Operating Instructions
6SE6400-5CA00-0BP0 77
Alarms and Warnings (P0004 = 21)
ParNr ParText Default Acc WS QC
P0952 Total number of faults 0 3 CT N
r0947[8] Last fault code - 2 - -
r0949[8] Fault value - 3 - -
r0948[12] Fault time - 3 - -
P2100[3] Alarm number selection 0 3 CT N
P2101[3] Stop reaction value 0 3 CT N
P2111 Total number of warnings 0 3 CT N
r2110[4] Warning number - 2 - -
r2114[2] Run time counter - 3 - -
P2150[1] Hysteresis frequency f_hys 3.00 3 CUT N
P2155[1] Threshold frequency f_1 30.00 3 CUT N
P2156[1] Delay time of threshold freq f_1 10 3 CUT N
P2164[1] Hysteresis frequency deviation 3.00 3 CUT N
P2167[1] Switch-off frequency f_off 1.00 3 CUT N
P2168[1] Delay time T_off 10 3 CUT N
P2170[1] Threshold current I_thresh 100.0 3 CUT N
P2171[1] Delay time current 10 3 CUT N
P2172[1] Threshold DC-link voltage 800 3 CUT N
P2173[1] Delay time DC-link voltage 10 3 CUT N
P2179 Current limit for no load ident. 3.0 3 CUT N
P2180 Delay time for load missing 2000 3 CUT N
r2197 CO/BO: Monitoring word 1 - 2 - -
PI Controller (P0004=22)
ParNr ParText Default Acc WS QC
P2200[1] BI: Enable PID controller 0:0 2 CUT N
P2201[1] Fixed PID setpoint 1 0.00 2 CUT N
P2202[1] Fixed PID setpoint 2 10.00 2 CUT N
P2203[1] Fixed PID setpoint 3 20.00 2 CUT N
P2204[1] Fixed PID setpoint 4 30.00 2 CUT N
P2205[1] Fixed PID setpoint 5 40.00 2 CUT N
P2206[1] Fixed PID setpoint 6 50.00 2 CUT N
P2207[1] Fixed PID setpoint 7 60.00 2 CUT N
P2216 Fixed PID setpoint mode - Bit 0 1 3 CT N
P2217 Fixed PID setpoint mode - Bit 1 1 3 CT N
P2218 Fixed PID setpoint mode - Bit 2 1 3 CT N
r2224 CO: Act. fixed PID setpoint - 2 - -
P2231[1] Setpoint memory of PID-MOP 0 2 CUT N
P2232 Inhibit rev. direct. of PID-MOP 1 2 CT N
P2240[1] Setpoint of PID-MOP 10.00 2 CUT N
r2250 CO: Output setpoint of PID-MOP - 2 - -
P2253[1] CI: PID setpoint 0:0 2 CUT N
P2254[1] CI: PID trim source 0:0 3 CUT N