Symbol Technologies SPT 1700 - Manual (Page 71)

2-21
Network Setup
RSSI Entry is the signal strength measured on the current channel. During the SEARCH
phase of operation, this value may vary according to the channel on which an attempt will
be made. When ACQ'D, the signal strength measurement should remain somewhat
constant.
IP is the IP address of the unit.
EID is the Equipment ID of the unit.
Color Area color code being transmitted by the CDPD system.
Chan The current channel. During the SEARCH phase, this value may
change according to the channel that is being attempted. Once a
channel has been ACQ'D, this should remain relatively constant.
CellID CDPD Base Station identifier number.
BLER A measurement of the error rate on the forward channel detected by
the modem.
Side Display of the current Side, given the A/B side distribution of the CDPD
channels.
PL The current Power Level value at which transmission will take place.
SPI The current CDPD Base Station Service Provider Identifier.
WASI The current CDPD Base Station Wide Area Service Identifier.
SPNI The current CDPD Base Station Service Provider Network Identifier.
PwrProd The Power Product value transmitted by the current CDPD system.
RegErr A numeric value representing the last registration error encountered. A
value of 1-7 indicates an error; a value of 0 indicates no error and a
value of 255 indicates no registration attempt was made.
Link Identifies the current CDPD communication link state. Can be Locked
or Searching.