Symbol Technologies SPT 1700 User Manual
Page 60
2-10
SPT 1700 Series Product Reference Guide
3.
Tap Other if you need to enter a Service Provider Interface number representing a
different carrier. The following screen displays:
4.
Enter the SPI number and tap Done.
5.
The Network Provider screen reappears. Tap Next to continue.
Note: The Setup Wizard will not proceed until a CDPD carrier selection
has been made.
6.
The Configure Palm Device screen displays:
7.
Tap the Configure Preferences button to configure the terminal with the network
library settings that Symbol recommends. A “Palm Configuration Complete”
message will display below the Configure Preferences button when the process is
finished.
Note: If you are confident that the Network Preferences are correct, you
may bypass this step. However, it strongly suggested that you verify
preference configuration.