Sanyo DHX4852 User Manual
Page 88
3-40
Control of W-2WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
4. System Controller
When the indication is displayed, you cannot change the
mode from and or to or and . To change the
mode, turn off all units once then select the mode again.
TD831078
III - 28
D:ON button
This button is for turning the selected air conditioner on.
E:OFF button
This button is for turning the selected air conditioner off.
F:Operation lamp
This lamp lights when the unit is turned on.
G:MODE button
Use this button to select one of the following five operations:
(AUTO)
: Used to automatically set cooling or heating operation.
Only for heat pump type
(temperature range: 62 ~ 80
°F)
(HEAT)
: Used for normal heating operation.
(DRY)
: Used for dehumidifying without changing the room temperature.
(COOL)
: Used for normal cooling operation.
(FAN)
: Used to run the fan only, without heating or cooling operation.
H:Temperature
setting buttons
: Press this button to increase the temperature setting.
: Press this button to decrease the temperature setting.
I:FAN SPEED button
(AUTO)
: The air conditioner automatically decides the fan speed.
(HI.)
: High fan speed.
(MED.)
: Medium fan speed.
(LO.)
: Low fan speed.
J:FLAP button
1. Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.
•
In the cool mode and dry mode, when the flaps are set
in a downward position, condensation may form and drip
around the vent.
•
Do not move the flap with your hands.
This function is available only for models X, A and T.
( )
2. Use this button to make the airflow direction sweep up and down
automatically.
Press this button several times until the ( ) symbol appears on
the display.
This function is available only for models X, A, K and T.
1) The flap setting can be performed only for units that have no remote
controllers.
2) In the ALL or ZONE mode, no flap setting can be performed. If
necessary, you should select the GR mode and use the FLAP button.
NOTE
Operation mode
(COOL) or (DRY)
(HEAT) or (FAN)
(AUTO)
Cooling mode:
Heating mode:
Number of airflow direction settings
3
5
3
5
NOTE
Functions of buttons
(Continued)
NOTE
NOTE
( )
Only for heat pump type
(temperature range: 60 ~ 78
°F)
(temperature range: 64 ~ 86
°F)
(temperature range: 64 ~ 86
°F)
TD831138-02_W-2WAY.indb 40
2007/07/26 14:31:44