Sanyo DHX4852 - Manual (Page 58)

3-10
Control of W-2WAY ECO-i SYSTEM
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
2. Wireless Remote Controller
1 1
2 1
3 1
4
6
7
5
Fastening screw Remote
control unit
Remote
control holder
Parts Q'ty Parts Q'ty
AAA alkaline
battery
Receiver
unit Tapping screw
5/32” 5/8”
Ч
5/32” 15/32” Ч
Clamp
No. No.
2
2
1
1
2PWHT
CN001
WHT
BLK
Indoor unit Receiver PCB
Remote controller
Terminal board
Connect the wire from the receiver unit to the indoor unit
remote controller terminal board. (The wire has no polar-
ity.)
2-4. Precautions on Simultaneous Installation of
Wired Remote Controller and Wireless Remote
Controller
By installing a wired remote controller, the wireless remote
controller kit can permit dual remote control operation at the
same time.
(Up to 2 units of remote controllers - a wireless kit and a wired
unit - can be installed.)
Dual remote control operation can control 1 or multiple air
conditioners using several remote controllers.
2-2. Accessories
2-3. Wiring the Receiver Unit
Connection diagram
Be sure to determine the correct terminal numbers on
the indoor unit when wiring the remote controller. The
remote controller will be damaged if high voltage (such
as 200 VAC) is applied.
The wireless remote controller kit components cannot
be used for more than 1 indoor unit at a time. (However,
separate receiver units may be used simultaneously.)
When a wireless remote controller kit and a wired re-
mote controller are used simultaneously, assign either
the wireless remote controller or the wired remote
controller as the sub remote controller unit.
WARNING
CAUTION
TD831138-02_W-2WAY.indb 10 2007/07/26 14:31:17