Siemens 2011 - Manual (Page 96)

Important notes on putting into service and operation
85
kap18.fm5 18.7.99 Gigaset 2011 Comfort, GBR: A30852-X1106-B307-1-
Important notes on putting into service and operation
Installing the base station
Installation site/installation area
● A 220/230 V AC power socket must be located at the
installation site.
● In order to avoid interference, the base station should
not be in the direct vicinity of other electronic equip-
ment such as Hi-fi, office or microwave equipment.
● Place the base station on a flat, non-slip surface. Un-
der normal circumstances, the rubber feet will not
leave marks. However, due to the vast array of surface
finishes applied to furniture, marks on the installation
surface cannot be entirely ruled out.
● Radio transmission between the base station and
handsets complies with the DECT standard. Gigaset
2011 thus observes all relevant European regulations.
However, if there is interference to the picture or
sound of your satellite equipment, consult your spe-
cialist satellite dealer.
● Depending on ambient conditions, the maximum ra-
dio range between the base station and the handset
is approx. 300 m outdoors, and approx. 50 m indoors.
If the range warning is activated for the handset
(➔ page 56), a signal will sound when you move out-
side the radio range.
Temperature/ambient conditions
● The base station is designed for operation in protect-
ed areas with a temperature range from +5 °C to
+45° C.
● The base station should not be installed in damp are-
as (such as bathrooms or laundry rooms), close to
heat sources or in direct sunlight.