Siemens 2011 User Manual
Page 58
Important basic settings
47
kap09.fm5
18.7.99
Gigaset 2011 Comfort, GBR: A30852-X1106-B307-1-
Operating in a telephone system
To be able to operate your Gigaset 2011 in a telephone
system, you must first
1. check the signalling method,
2. enter the analog trunk or MSI
3. enter the pause lengths after the
analog trunk or MSI.
Possible signalling method settings
The factory default for the signaling method is
●
DTMF/Flash.
You must first reset this setting to one of the following in
order to operate your handset in telephone systems:
●
DP
or
●
DTMF/Flash.
Please also consult the instructions for use supplied with
your telephone system.
(
t means: scroll with
u
,
confirm with
x
)
Z
OK
Call number display (CLIP) can only be used if
supported by the telephone system.
.t Service
Activate the Service menu item.
#1 Start the setting procedure.
o
Enter the four-digit base code (factory default: "0000")
(➔ page 43).
u
@33x
Set dial pulsing (DP)
or
u
@37x
Dual-tone multifrequency signalling DTMF/Flash
REDIAL
SET
REDIAL
SET