Siemens 2011 User Manual
Page 15
Step by step guide to putting into service
4
kap02.fm5
18.7.99
Gigaset 2011 Comfort, GBR: A30852-X1106-B307-1-
Step 6: Check the signalling method
Telecom telephone lines can operate with the following
signalling methods:
●
Dial pulsing (DP)
●
Dual-tone multifrequency signalling (DTMF)
Your Gigaset 2011 is set to DTMF signalling by default.
Checking your own telephone’s signalling method
Setting dial pulsing
Gigaset 2011 is ready for operation.
c
Press the Talk key. You will hear the dial tone (on-hook sig-
nal).
o
Press any digit, e.g. 2. If you can still hear the dial tone
(on-hook signal), you must set the signalling method to
dial pulsing (DP).
. Press the menu key on the keypad.
Press the left display key until Service is displayed.
Press the right display key for OK to confirm your selec-
tion.
#1 Initiate the procedure.
o
Enter the four-digit base code; (factory default: "0000")
(➔ page 43).
u
@33 x
Set dial pulsing (DP).
REDIAL
SET
The settings "DTMF/Flash" or "DP" are only
needed to operate your Gigaset 2011 at the
main station telephone.
The other signalling method settings are intend-
ed for operating Gigaset 2011 in telephone sys-
tems (➔ page 47).