Samsung DVW-707/707P - Manual (Page 40)

Chapter 2 Locations and Functions of Parts and Controls
2-24
2
Shooting and playback/record functions (3)
wa TEST OUT (test output) connector (BNC type)
This connector outputs the video signal (standard level, 75-ohm
terminated) for the video monitor. The output signal can be selected to be
a composite, R, G, or B. The factory setting is composite, and the setting
returns to composite whenever the power is switched on.
Depending on the internal board and setup menu settings, the setup
menu, the time code and the shot data can be displayed over the image
on the monitor. As for the VIDEO OUT connector, you can use this
connector for synchronizing the time code of an external VTR to the
time code of the camcorder.
For information about the setting for test output, see Section 4-9-3 “Selecting the
Test Output” (page 4-83).
wa