Servis-Rhino RHINO AGM72 - Manual (Page 16)

SAFETY
The rotating parts of this machine have been designed and tested for rugged use. However, the
blades could fail upon impact with heavy, solid objects such as metal guard rails and concrete
structures. Such impact could cause the broken objects to be thrown outward at very high
velocities. To reduce the possibility of property damage, serious injury, or even death, never
allow the cutting blades to contact such obstacles.
(SGM-4)
Extreme care should be taken when operating near loose objects such as gravel, rocks, wire,
and other debris. Inspect the area before mowing. Foreign objects should be removed from the
site to prevent machine damage and/or bodily injury or even death. Any objects that cannot be
removed must be clearly marked and carefully avoided by the operator. Stop mowing
immediately if blades strike a foreign object. Repair all damage and make certain rotor or blade
carrier is balanced before resuming mowing.
(SGM-05)
SA
F
ET
Y
Many varied objects, such as wire, cable, rope, or chains, can become entangled in the
operating parts of the mower head. These items could then swing outside the housing at
greater velocities than the blades. Such a situation is extremely hazardous and could result in
serious injury or even death. Inspect the cutting area for such objects before mowing. Remove
any like object from the site. Never allow the cutting blades to contact such items.
(SGM-06)
Mow at the speed that you can safely operate and control the tractor and mower. The correct
mowing speed depends on terrain condition and grass type, density, and height of cut. Normal
ground speed range is from 2 to 5 mph(3-8 kph). Use slow mowing speeds when operating on
or near steep slopes, ditches, drop-offs, overhead obstructions, power lines, or when debris and
foreign objects are to be avoided.
(SGM-07)
Avoid mowing in reverse direction when possible. Check to make sure there are no persons
behind the mower and use extreme care when mowing in reverse. Mow only at a slow ground
speed where you can safely operate and control the tractor and mower. Never mow an area
that you have not inspected and removed debris or foreign material.
(SGM-08)
Do not mow with two machines in the same area except with Cab tractors with the windows
closed.
(SGM-11)
AGM 52-62-72-82 10/10 Safety Section 1-10
© 2010 Alamo Group Inc.