Servis-Rhino RHINO AGM72 - Manual (Page 140)

OPERATION
Working Position
To move from the transport position to the work position proceed as follows:
BEFORE STARTING OPERATION, MAKE SURE THERE ARE NO PEOPLE OR ANIMALS
IN THE VICINITY OF THE MOWER.
1. Send the cylinder shaft backwards slightly but keep rope 3 stretched until pin 2 is unlocked. (See Figure 12)
2. Extend the cylinder until the disc carrier bar is horizontal.
3. Lower the mower, fasten adjustment chain 2 to the tractor’s top link support bracket and adjust to maintain the
ground-to-linkage height of 19.7”.(See Figure 13)
4. Lower protection plate and check that the driveline is connected to mower.
O
PER
A
T
IO
N
Make sure the adjustment chain is always well stretched when machine is working to prevent
pin from being damaged.
AGM 52-62-72-82 10/10 Operation Section 4-30
© 2010 Alamo Group Inc.