Servis-Rhino RHINO AGM72 - Manual (Page 159)

MAINTENANCE
Disc Replacement
Reinstalling Disc Assemblies: Disc should be installed on the spline shaft as shown in Image Mnt-D-0002 for different
model. The cutting edges of the blade should face the disc rotation direction. Blades are reversible.
ALWAYS REPLACE BLADES AND BLADE FASTENERS IN PAIRS TO MAINTAIN
BALANCE. VIBRATION MAY LEAD TO COMPONENT FAILURE.
To remove the disc, remove the 6 bolts (D), See Image
Mnt-D-0001.
To remove the hub (E), remove the locknut (F)
and the conical washer (G). Pull the hub upward evenly to remove. Gearpullers may be required to remove hub from
spline shaft. See Image
MntP-D-0001.
M
A
IN
T
EN
A
N
C
E
AGM 52-62-72-82 10/10 Maintenance Section 5-3
© 2010 Alamo Group Inc.