Servis-Rhino RHINO AGM72 - Manual (Page 141)

OPERATION
Driving the Tractor and Mower
Start off driving at a slow speed and gradually increase your speed while maintaining complete control of
the tractor and mower. Moving slowly at first will also prevent the tractor from rearing up and loss of
steering control. The tractor should never be operated at speeds that cannot be safely handled or which
will prevent the operator from stopping quickly during an emergency. If the power steering or engine
ceases operating, stop the tractor immediately as the tractor will be difficult to control.
Perform turns with the tractor and mower at slow speeds to determine how the tractor with an attached
mower handles a turn. Determine the safe speed to maintain proper control of the tractor when making
turns. When turning with a towed implement, the overall working length of the unit is increased. Allow
additional clearance for the mower when turning.
To avoid overturns, drive the tractor with care and at safe speeds, especially when operating over rough
ground, crossing ditches or slopes, and turning corners. Tractor wheel tread spacing should be increased
when working on inclines or rough ground to reduce the possibility of tipping.
Use extreme caution when operating on steep slopes. Keep the tractor in a low gear when going downhill.
DO NOT coast or free-wheel downhill.
OPS-R-0019_B
O
PER
A
T
IO
N
Crossing Ditches and Steep Inclines
When crossing ditches with steep banks or
going up sharp inclines, it is possible that the
main driveline inner profile will penetrate into the
outer housing to its maximum depth until the
assembly becomes solid (driveline is at its
extreme shortest length). This type of abusive
operation can cause serious damage to the
tractor and mower drive by pushing the PTO into
the tractor and through the support bearings or
downward onto the PTO shaft, breaking it off.
Damage resulting from over-collapse of the driveline’s inner profile and its outer housing may
allow the driveline to come loose from the Tractor which could cause bodily injury to the
operator or bystanders and/or extensive damage to the Tractor or Implement.
OPS-R-0020
AGM 52-62-72-82 10/10 Operation Section 4-31
© 2010 Alamo Group Inc.