Sherwood Newcastle R-972 - Manual (Page 68)

E
N
G
L
IS
H
68
■
Memorizing the adjusted channel levels
• You can memorize the adjusted channel levels into preset memory("REF 1", "REF 2") and recall the memorized whenever you
want.
■
Recalling the memorized channel levels
• "TRIM" may be displayed instead of "REF 1" or "REF 2".
• Then the channel levels memorized into the selected
preset memory are recalled.
2.
After performing the steps 2~4 in "Adjusting the current channel level" procedure on page 67, press the
CURSOR UP(
▲)/DOWN(▼) buttons to select a channel (, not the Mode (memory mode) and the LFE), then
press the ENTER button.
3.
Press the CURSOR LEFT(
◀)/RIGHT(▶) buttons to select the desired one of REF 1 and REF 2.
• Each time the CURSOR LEFT(
◀) or RIGHT(▶) button is
pressed, "REF 1" or "REF 2" is selected.
• The adjusted channel levels have now been memorized
into the selected memory.
3.
Press the CURSOR LEFT(
◀)/RIGHT(▶) buttons to select the desired preset memory, then press the
ENTER button.
2.
Press the CURSOR UP(
▲)/DOWN(▼) buttons to select the Mode(memory mode).
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:01 페이지 68