Sherwood Newcastle R-972 User Manual
Page 24
E
N
G
L
IS
H
24
• If the command has been learned successfully, "OK" is
displayed and then "SEL" is flickering.
• If "ERROR" is displayed and then "SEL" is flickering, it
means that for some reason the command was not
learned. In this case, repeat the above steps 4 and 5.
■
Notes :
• If an incorrect signal has been sent or, in some cases,
the command from other remote control simply cannot
be learned.
• In some "ERROR" cases, the remote controls just need
to be moved closer together or farther apart.
Programming the commands from other
remote controls (LEARNING mode)
• Then "SEL" is flickering.
• If "SEL" goes off, start again from the above
step 2.
• If the setup codes are not available for your component
or you want to program a missing or special function into
one button of a device, the learning function enables this
remote control to learn the commands from other remote
controls.
• Then "READY" is displayed.
■
Note:
• You cannot program a function into some buttons such
as DEVICE, MACRO and LIGHT buttons.
■
To exit from the setting mode, press any of the
DEVICE buttons.
• Then "LEARN" is displayed on the LCD screen for
several seconds
■
Note :
• During setting operation, to exit from the setting mode,
press any of the DEVICE buttons.
1.
Place this remote control and other remote
control facing each other at a distance of 5 to 15
cm (2 to 6 inches ) apart.
2.
Press and hold down the ENTER button and the
desired one of the DEVICE buttons for more
than 2 seconds.
3.
While "LEARN" is displayed, press the ENTER
button.
4.
While "SEL" is flickering, on this remote control,
press the button corresponding to the function to
be learned.
5.
While "READY" is displayed, on the other
remote control, press the button of the function
to be learned.
8.
Operate the newly programmed buttons to make
sure the learning function was performed
properly.
7.
Repeat the above steps 1 to 6 to program the
commands from a different remote control.
6.
While "SEL" is flickering, repeat the above steps
4 and 5 to program all the commands you want
to the buttons on this remote control under the
same device mode.
Example: If the function to be learned is playback, press
the PLAY(
▶
) button.
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 24