Sherwood Newcastle R-972 - Manual (Page 29)

29
3.
While the device is displayed, press the
CURSOR UP(
▲)/DOWN(▼) buttons to select
the one punch-through deleting mode
("DELETE"), then press the ENTER button.
2.
While "VOL" is displayed, press the CURSOR
UP(
▲)/DOWN(▼) buttons to select the all
punch-through deleting mode ("DELETE").
3.
While "DELETE" is displayed, to erase all the
punch-through functions programmed under the
master device mode, press ENTER button.
4.
To erase all the punch-through functions
programmed under other master device mode,
repeat the above steps 1 to 3.
1.
Perform the steps 3 and 4 in "Entering a setup
code" procedure on page 22 to select a master
device and the punch-through mode ("PUNCH").
4.
While the punch-through mode is displayed,
repeat the above steps 2 and 3 to erase other
punch-through function under the same master
device mode.
5.
To erase punch-through functions under other
master device mode, repeat the above steps 1
to 4.
• Each time the CURSOR UP(
▲
)/DOWN(
▼
) buttons
are pressed, depending on the selected punch-
through mode, the punch-through devices and the
deleting mode ("DELETE") are selected.
• Then "OK" is displayed and the current punch-
through mode is displayed .
Erasing all the punch-through functions
programmed under a master device mode
• Then "OK" is displayed and "DELETE" is displayed.
• To exit from the deleting mode, press any of the
DEVICE buttons.
• Each time the CURSOR UP(
▲
)/DOWN(
▼
) buttons are
pressed, the mode changes as follows:
→ VOL ↔ DELETE ↔ PLAY ↔ CH ←
• Then "DELETE" is displayed .
• Then "VOL" is displayed on the LCD screen for several
seconds.
Continued
E
N
G
L
IS
H
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 29