Sherwood Newcastle R-972 - Manual (Page 21)

E
N
G
L
IS
H
21
LoADInG BAtteRIes
oPeRAtInG coMPonents WItH ReMote contRoL ReMote contRoL oPeRAtIon RAnGe
■In case that this remote control emits the infrared beams
• Use the remote control within a range of about 7 meters
(23 feet) and angles of up to 30 degrees aiming at the
remote sensor.
■In case that this remote control emits the RF beams
• Use the remote control within a distance of about 15 meters
(50 feet) toward this receiver.
■Notes :
• When you cannot operate any component, check if the
transmission signal mode is set to "RF". (For details,
refer to "Changing the transmission signal" on page 30.)
• In this case, to operate the component, connect the IR
emitter to the IR OUT jack and use the remote control
toward this receiver. (For details, refer to
"CONNECTING RF REMOTE ANTENNA" on page 14
and "CONNECTING MULTI-ROOM SYSTEM KIT" on
page 15.)
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several
minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should
this happen, you should memorize them again.
• Remove the batteries when they are not used for a long
time.
• Do not use the rechargeable batteries (Ni-Cd type).
• Be sure to use alkaline batteries.
1.
Enter the setup code for each component other
than this receiver. For details, refer to "Entering
a setup code" on page 22.
2.
Turn on the component you want to operate.
1.
Remove the cover.
2.
Load four alkaline batteries ("AAA" size, 1.5V)
matching the polarity.
3.
Press the DEVICE button on the remote control
corresponding to the component you wish to
operate.
4.
Aim the remote control at the REMOTE
SENSOR of the component you wish to control
and press the button corresponding to the
operation you want.
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 21