Sherwood Newcastle R-972 User Manual

Page 40

Continued

■To cancel the surround mode for stereo operation

• The Dolby Headphone function simulates 5.1 channel

surround sound, which allows you to enjoy 5.1 channel
surround sound through 2 channel headphones, just
like listening from 5.1 channel speakers.

■Notes :
• Only when the SPEAKER button is set to off, the Dolby

Headphone mode can be selected.

• When playing the digital signals from multi channel

PCM, Dolby Digital Plus, Dolby TrueHD, DTS-HD High
Resolution Audio or DTS-HD Master Audio sources, the
2 CH downmix mode only can be selected.

• Switch the speakers off to listen with headphones.

Listening in Dolby Headphone mode

• The volume level of each channel can be adjusted

easily with the test tone function.

■

Notes :

• When the SPEAKER button is set to off, the test tone

function does not work.

• When EXTERNAL IN or USB is selected as an input

source, the test tone function does not work.

• Only when the Trinnov Position is set to "None", the test

tone function will work. (For details, refer to "When
selecting the Trinnov Position" on page 72.)

Adjusting each channel level with test tone

• The test tone will be heard from the speaker of each

channel for 2 seconds as follows:

Front Left Front Right Surround Right

Subwoofer Surround Left Surround Back Surr.Back Left Surr.Back Right

• When the speaker setting is "No", the test tone of the

corresponding channel is not available.

• ( ) : Possible depending on whether the surround back

channel is set to "2 ch" or "1 ch".

• You can select the desired channel with pressing the

CONTROL UP/DOWN (

▲/▼) buttons or the CURSOR

UP/DOWN (

▲/▼) buttons.

Enter the test tone mode.

Cancel the test tone function.

At each channel, adjust the level as desired until

the sound level of each speaker is heard to be
equally loud.

• Then " Headphone" (or " H ~ ") is displayed and the

Dolby Headphone mode is selected.

• To cancel the Dolby Headphone mode, press the

SPEAKER button again.

• Depending on the signal format which is being input,

either the stereo mode or the 2CH downmix mode is
selected.

• To cancel either the stereo mode or the 2CH downmix

mode, select the surround mode with using the MULTI
CONTROL knob on the front panel or the SURROUND
MODE UP/DOWN (

>/<) buttons on the remote control.

• When the Trinnov Position is not set to "None", if the

stereo mode or the 2CH downmix mode is selected,
sound may be heard from speakers other than front
speakers. (For details, refer to "When selecting the
Trinnov Position" on page 72.)

■2CH downmix mode
• This mode allows the multi-channel signals encoded in

DTS or Dolby Digital format, etc. to be mixed down into
2 front channels and to be reproduced through only two
front speakers or through headphones.

• When the SPEAKER button is set to off to listen with

headphones, if the STEREO button is pressed while
playing the multi-channel digital signals from DTS or
Dolby Digital sources, etc., it will enter the 2CH
downmix mode automatically.

• To cancel the 2CH downmix mode, select the Dolby

Headphone mode with using the MULTI CONTROL
knob on the front panel or the SURROUND MODE
UP/DOWN (

>/<) buttons on the remote control.

R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 40