Sherwood Newcastle R-972 - Manual (Page 66)

E
N
G
L
IS
H
66
■
When selecting the desired unit
• You can select either Meters or Feet.
• Once a unit is selected, the distances are automatically
changed in the selected unit.
■
When setting the distance
• You can set the distance within the range of 0.1 ~ 9.0
meters in 0.1 meter intervals (or 0.5 ~ 30 feet in 0.5 feet
intervals).
When selecting the Speaker Distance
■
Note :
• You cannot select the subwoofer and the speakers set to
"No".
■
About the speaker distance
When enjoying multi-channel surround playback with Dolby Digital and DTS sources, etc., it is ideal that the center, surround,
surround back and subwoofer speakers should be the same distance from the main listening position as the front speakers. By
entering the distance between the listening position and each speaker, the delay times of center, surround, surround back and
subwoofer speakers are automatically adjusted to create an ideal listening environment virtually as if the center, surround,
surround back and subwoofer speakers were at their ideal locations respectively.
1.
Press the CURSOR UP(
▲)/DOWN(▼) buttons to select the Speaker Distance, then press the ENTER button.
2.
Press the CURSOR UP(
▲)/DOWN(▼) buttons to select the desired item.
3.
Press the CURSOR LEFT(
◀)/RIGHT(▶) buttons to set the selected item as desired.
4.
Repeat the above steps 2 and 3 until the distances are all set as desired.
• Only when the Trinnov Position is set to "None", you can set the Speaker Distance manually. (For details, refer to "When
selecting the Trinnov Position" on page 72.)
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:01 페이지 66