Sherwood Newcastle R-972 User Manual
Page 55
E
N
G
L
IS
H
55
E
N
G
L
IS
H
■
Notes:
• Even when this receiver enters the standby mode, in
such a case that the POWER ON/STANDBY button
lights up blue (and " " lights up still) as it does in
the operating mode, meaning only the ROOM 2 circuitry
operates, the ROOM 2 source can be played
independently.
• When you do not use the ROOM 2 function, turn it off to
save electricity.
• ROOM 2 ~ is displayed for several seconds.
• When the ROOM 2 setting mode disappears, press the
ROOM 2 button again.
• ROOM 3 ~ is displayed for several seconds.
• When the ROOM 3 mode disappears, press the ROOM 3
button again.
• Each time these buttons are pressed, the
mode changes as follows :
→ROOM 2 ~ : To turn on or off the
(ROOM 2 mode) ROOM 2 function.
↕
INPUT ~ : To select the desired
(ROOM 2 input)
ROOM 2 source.
↕
VOLUME ~ : To adjust the ROOM 2
(ROOM 2 volume) volume.
↕
R2 BASS ~ : To adjust bass for ROOM 2
↕
source.
→R2 TRE ~ : To adjust treble.
■
When selecting the ROOM 2 mode.
ON : To turn on the ROOM 2 function.
↕
(" " lights up.)
OFF : To turn it off. (" " or " "
goes off depending on the AMP ASSIGN
setting.)
■
When selecting the ROOM 2 input.
• You can select the desired among MAIN source,
TUNER, CD, TAPE, VIDEO 1 ~ VIDEO 5 as a ROOM 2
source.
1.
Press the ROOM 2 button to enter the ROOM 2
mode.
3.
Set the selected mode as desired.
4.
Start play on the component related to the
ROOM 2 source.
1.
Press the ROOM 3 button to enter the ROOM 3
mode.
ON : To turn on the ROOM 3 function and to play the
↕
same source that you select for main room.
OFF : To turn it off.
2.
Set the ROOM 3 mode as desired.
2.
Select the desired mode while displaying the
ROOM 2 setting mode.
Continued
◆When using the buttons on the front panel
• You cannot select a different source for ROOM 3 and
can play only the audio signals from the same source
that you select for main room.
Listening to ROOM 3 source
■
Note :
• When the ROOM 2 mode is set to OFF, the ROOM 2
input, the ROOM 2 volume and the tone (bass and
treble) cannot be selected.
■
When selecting the ROOM 2 volume.
• You can adjust the ROOM 2 volume.
■
When selecting the tone (bass and treble).
• The tone level can be adjusted within the range of -10
~ +10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0 dB (flat level).
• Extreme settings at high volume may damage your
speakers.
R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:01 페이지 55