Sherwood Newcastle R-972 User Manual

Page 14

• Connect the XM terminal to the XM Mini-Tuner system

(sold separately).

• Position the XM Mini-Tuner system near a south-facing

window to receive the best signal.

When making connections, also refer to the operating
instructions of the XM Mini-Tuner system.

• For the best reception, check the signal strength of the XM

radio signal with using signal strength display mode, then
adjust the position of the XM Mini-Tuner system until
"SIGNAL : GOOD" is displayed. (For details, refer to
"Displaying XM information" on page 47.)

• To listen to XM Satellite Radio, refer to "XM Satellite Radio

(only for North America)" on page 45.

CONNECTING xM (only for North America)

10.

CONNECTING RF REMOTE ANTENNA

• Connect the supplied antenna to receive the RF (Radio

Frequency) beams from the universal remote control.

• If the antenna is connected to this receiver, even though

there are obstacles such as walls, furniture, etc. in the
way, you can control this receiver with the universal
remote control. Therefore, you can control this receiver
from another room with the universal remote control
without connecting the multi-room system kit. (For details,
refer to "CONNECTING MULTI-ROOM SYSTEM KIT" on
the next page.)

■Note:

• If the walls are too thick or the distance exceeds the

operation range, you cannot control this receiver with the
universal remote control. In such a case, connect the
multi-room system kit to this receiver and set the
transmission signal mode to "IR" (Infrared). (For details,
refer to "Changing the transmission signal" on page 30.)

11.

CONNECTING MICROPHONE

• To use Auto Setup function, connect the supplied

microphone to the Trinnov Mic connector. (For details,
refer to "When selecting the Auto Setup Trinnov
Optimizer" on page 61.)

■Notes:

• Because the microphone for Auto Setup is especially

• After you have completed the auto setup procedure,

disconnect the microphone.

R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 14