Sherwood Newcastle R-972 User Manual

Page 30

Changing the transmission signal

• This remote control can emit not only the infrared beams

which the conventional remote control uses but also the
RF(Radio Frequency) beams which are stronger than
those.

• When you want to control this receiver from longer

distance even if there are obstacles such as walls,
furniture, etc. in the way, change the transmission signal
into "RF"(Radio Frequency).

■

Notes:

• When the RF remote antenna is not connected, remote

operation will become unreliable. (For details, refer to
"CONNECTING RF REMOTE ANTENNA" on page 14.)

• If the transmission signal mode is set to "RF" (Radio

Frequency), this remote control cannot control other
audio and video components.

• In this case, to control the component, connect the IR

emitter to the IR OUT jack. (For details, refer to
"CONNECTING MULTI-ROOM SYSTEM KIT" on page
15.)

Press and hold down the ENTER button and the

AUDIO button for more than 2 seconds.

• Then "LEARN" is displayed on the LCD screen for

several seconds.

■

Note:

• During setting operation, to exit from the setting mode,

press any of the DEVICE buttons.

While "LEARN" is displayed, press the CURSOR

UP(

▲)/DOWN(▼) buttons to select the

transmission signal mode("RF-IR"), then press
the ENTER button.

• Then "RF" (or "IR") is displayed.
• If "RF" (or "IR") goes off, start again from the above step 1.

While "RF" (or "IR") is displayed, press the

CURSOR UP(

▲)/DOWN(▼) buttons to select

the desired transmission signal, then press the
ENTER button.

To pair up this remote control and the receiver,

press the TUNING UP(+) button and the
ENTER/MEMORY button simultaneously on the
receiver.

While "RF REMOCON PAIRING MODE" is

displayed, press the ENTER button, aiming at the
receiver.

• Each time the CURSOR UP(

▲

)/DOWN(

▼

) buttons are

pressed, the mode changes as follows :

"RF" : This remote control emits the RF(Radio Frequency)

beams which are stronger than the infrared beams.

"IR" : This remote control emits the infrared beams which

the conventional remote control uses.

• Then "OK" is displayed.

• "RF REMOCON PAIRING MODE" is displayed for

several seconds on the display of the receiver.

• If "RF REMOCON PAIRING MODE" goes off, press

these buttons again.

• Then "PAIRING SUCCESS" is displayed.

■

When "RF" is set to.

↕

R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:00 페이지 30