Sanyo CHX06052 - Manual (Page 44)

2-26
Remote Control Functions
3. Timer Remote Controller (RCS-TM80BG)
Deleting the program Timer
To delete the program timer setting, follow the steps below.
1. press
to enter the program confirmation mode.
2. press / to select the day of the program you want to de-
lete.
3. press / to select a TIMER No. (from 1 to 6).
4. press to display the program setting mode .
5. press to delete the program.
Note
After deleting, the unit returns to the program confirmation mode .
If you press
during the setting, the unit returns to the program
confirmation mode.
If there is no operation made for 3 minutes during the setting, the unit re-
turns to the normal mode.
Invalidating program Timer
If you want to adjourn the program operation for more than 1 week, you can
invalidate all the timer settings.
Once the timer settings are invalidated, the program will not be operated until the invalidation is cancelled.
<>
Press and hold for more than 2 seconds.
is displayed and the programs will be invalidated from the next one.
<>
Press and hold for more than 2 seconds.
disappears and the programs will be validated from the next one.
If power Failure Occurred
If the power recovers in a short time period, the program after the recovered time will be valid.
If the power recovered more than 1 hour after the failure, the present time information will be lost. In this case, the program will
not be operated.
4 3 5 1 2
MiniECO-i.indb 26 2007/06/20 16:28:41