Sanyo CHX06052 - Manual (Page 40)

2-22
Remote Control Functions
3. Timer Remote Controller (RCS-TM80BG)
10. Setting the present Time
1. press and hold for more than 2 seconds to enter in the present
day and time setting mode.
Once you enter in the setting mode,
, “ ”(day) and “time” flash.
2. Set “ ” to today’s day of the week.
Press * 1 to move “ ” (flashing on the display) in the order of :
Su Mo Tu .... Press to move it in the order of : Su St
Fr ....
*1 While in time setting mode, the temperature setting buttons function as
(changing day) button.
3. press to change the present “hour” in the range of 0 to 23* 2 .
Set the present hour and press .
The “hour” digits light up, and the “minute” digits start flashing.
*2 If the clock uses the 12 hours AM/PM setting, the hour is displayed in the range of AM 0 to
11/PM 0 to 11.
4. press , to change the present “minute” in the range of 0 to 59.
Set the present minute and press . The day and time are set and finishes the setting mode.
Note
• The unit returns to the normal mode if is pressed or there is no operation made for 3 minutes
during the setting. In this case, all the settings in progress will be lost.
• If the present time is invalid, “– – : – –” is displayed.
If the power failure for more than 1 hour occurs, check if the set data of day and time are valid.
1,3,4 3,4 2
MiniECO-i.indb 22 2007/06/20 16:28:36