JVC LVT0858-001A - Manual (Page 28)

24
Tuner Operations
MEMORY Source selecting button
(FM/AM)
Display
CONTROL
5/∞/3/2
Remote
NOT
Using Preset Tuning
Once a station is assigned to a channel number, the station can be
quickly tuned. You can preset up to 30 FM and 15 AM (MW/LW)
stations.
To store the preset stations
Before you start, remember...
There is a time limit in doing the following steps.
If the setting is canceled before you finish, start
from step
2 again.
1
Tune into the station you want to preset (see
“Tuning into Stations Manually” on page 23).
• If you want to store the FM reception mode for this station,
select the FM reception mode you want. See “Selecting the
FM Reception Mode” on page 25.
2
Press MEMORY.
The channel number position starts flashing on the display for
about 5 seconds.
ANALOG ST TUNED AUTO MUTING
MH Z
VOL
L R
ST TUNED AUTO MUTING
MH Z
VOL
MEMORY
CONTROL
ST TUNED AUTO MUTING
MH Z
VOL
3
Press CONTROL
3 (or 2) to select a channel
number while the channel number position is
flashing.
4
Press MEMORY again while the selected channel
number is flashing on the display.
The station is assigned to the selected channel number.
• The selected channel number stops flashing and then the
frequency starts flashing.
5
Press CONTROL 3 (or 2) to select another
frequency you want to store while the frequency
flashes on the display.
6
Repeat steps
1
to
5
until you store all the
stations you want.
To erase a stored preset station
Storing a new station on a used channel number erases the
previously stored one.
STB VCR TV TAPE FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST SETTING
STANDBY
INPUT ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND ON/OFF SURROUND MODE
ANALOG PL ΙΙ
SUBWFR LFE
SLEEP MODE TA ST TUNED INFO HEWS AUTO MUTING
MH Z KH Z VOL
AUTO
AUTO SR INPUT ATT
DSP L C R
LS S RS
LPCM DOLBY D DTS
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
PHONES
RDS HP
MEMORY
ST TUNED AUTO MUTING
MH Z
VOL
EN23-29.RX-E111&112RSL[B]_f 02.1.17, 9:20 AM 24