JVC LVT0858-001A - Manual (Page 26)

22
3
Press CONTROL
3 (or 2) to adjust the sound
output level.
• Pressing CONTROL 3 increases the sound output level
(from –10 to +10).
• Pressing CONTROL 2 decreases the sound output level
(from +10 to –10).
When using the remote control
1 Press SOUND.
10 keys now work for sound adjustments.
2 Press SUBWOOFER +/– to adjust the sound output level
(from –10 to +10).
Adjusting the Subwoofer Output Level
You can adjust the subwoofer output level if you have connected a
subwoofer and set the subwoofer information correctly—“YES”
(see page 15).
• You have to make this adjustment for each source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1 again.
1
Press ADJUST.
The CONTROL buttons now work for sound
adjustments.
2
Press CONTROL
∞ (or 5) repeatedly until
“SUBWFR (subwoofer)” (with the current
setting)* appears on the display.
* “0” is the initial setting. If you have already changed the
setting, another number (level) will be shown.
Sound Adjustments
ANALOG PR ΙΙ
SUBWFR LFE
VOL
AUTO SR
INPUT ATT
DSP
L C R
LS S RS
LPCM
DOLBY D
DTS
STB VCR TV TAPE FM/AM
TV DIRECT
DVD
MEMORY
CONTROL
ADJUST SETTING
STANDBY
INPUT ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND ON/OFF SURROUND MODE
ANALOG PL ΙΙ
SUBWFR LFE
SLEEP MODE TA ST TUNED INFO HEWS AUTO MUTING MH Z KH Z VOL
AUTO
AUTO SR INPUT ATT
DSP L C R
LS S RS
LPCM DOLBY D DTS
DVD STB VCR TV TAPE FM/AM
HOME CINEMA CONTROL CENTER
STANDBY/ON
PHONES
RDS HP
ADJUST
Display
CONTROL
5/∞/3/2
ADJUST
CONTROL
R ΙΙ
VOL
O SR
T ATT
CONTROL
EN20-22.RX-E111&112RSL[B]_f 02.2.6, 7:34 PM 22