Juniper Networks ERX-1410 - Manual (Page 88)

CHAPTER 5
Accessing the ERX System 5-6
Caution: Do not change the IP address for the Ethernet interface that you are
using to communicate with the system. If you change the address, you will lose the
Telnet session.
SNMP
The system supports Simple Network Management Protocol (SNMP), a
standard management protocol for IP networks. You can configure the
system as an SNMP agent.
As an SNMP agent, the system provides access to management
information that it maintains. See the
ERX System Basics Configuration
Guide, Chapter 3, Configuring SNMP for information on SNMP. See
the ERX Command Reference Guide for the commands that are
available for configuring the system as an SNMP agent.
The Next Step
Go to Chapter 6, Powering Up the System .