JBL SYNTHESIS SDP-40 - Manual (Page 84)

SETUP
SDP-40
3-44
ON-SCREEN DISPLAY
Selecting the DISPLAY SETUP menu ON-SCREEN DISPLAY option opens the ON-SCREEN DISPLAY menu shown below, which can be used to
customize the on-screen display.
ON-SCREEN DISPLAY DISPLAYS SETUP
DISPLAY SETUP
ON-SCREEN DISPLAY
FRONT PANEL DISPLAY
A/V SYNC DELAY
OFF
CUSTOM NAME OFF
EDIT CUSTOM NAME
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
SETUP
SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGERS
LOCK OPTIONS
DISPLAYS
ON-SCREEN DISPLAY
ON-SCREEN DISPLAY
STATUS 2 SECONDS
POSITION TOP
FORMAT NTSC
BACKGROUND ON
REMOTE STATE ON
ON
OFF
ALWAYS ON
2 SECONDS
ALWAYS OFF
TOP
CENTER
BOTTOM
SECAM
PAL
NTSC
Default Possible
Parameter Setting Settings
STATUS 2 SECONDS ALWAYS ON, 2 SECONDS,
ALWAYS OFF
POSITION TOP TOP, CENTER, BOTTOM
FORMAT NTSC SECAM, PAL, NTSC
BACKGROUND ON ON, OFF
REMOTE STATE ON ON, OFF
STATUS ALWAYS ON, 2 SECONDS, ALWAYS OFF
Controls the activation of the on-screen display when the display
device is connected to a Main Zone video output connector. When
ALWAYS ON is selected, the on-screen display remains activated at
STATUS ON-SCREEN DISPLAY DISPLAYS SETUP
all times. When 2 SECONDS is selected, the on-screen display
activates for two seconds whenever a new input source is present
or a new command is received. When ALWAYS OFF is selected, the
on-screen display remains deactivated at all times, and will not
reactivate until the STATUS parameter is reset to ALWAYS ON or 2
SECONDS.
Note:
When the ON-SCREEN DISPLAY menu STATUS
parameter is set to ALWAYS OFF, the on-screen display
immediately deactivates. Press the OSD button or use
the front panel display as a guide to reset the
ON-SCREEN DISPLAY menu STATUS parameter to
ALWAYS ON or 2 SECONDS.
. . . On-Screen Display continues on page 3-45